Frozen pipes may be somewhat common in the wintertime. If your pipes do freeze, you want to check and see if the pipes are busted or cracked. If your pipes are frozen, you can use a hair dryer to try and thaw out the pipes. However, if this will not work, you will need to call in a drain line repair who may either try and thaw the lines out another way or they may just end up replacing the section of the line that is broken.
If you find that the water line repair leak is in the supply line you will need to replace it or simply tighten it. Start by turning the water supply off and then flushing the toilet to get rid of the excess water. Now use the towels to dry the area so that it is easier for you to fix the leak. Use a wrench to loosen the hexagonal nuts on the supply line at the main end as well as the one which goes to the flush tank. Now use the replacement supply line which you have and tighten the bolt at the supply end first. Now adjust the length that you will need for the pipe to reach the flush tank. Once you adjust the length use a knife to cut the extra length and then tighten the hexagonal bolt at the other end.
There may be more pipes in your home than you think. Your home gets all the water it needs, either from a municipal water connection or from a well, through one central pipe, which branches out and distributes water to all the other places in your home that need it. These pipes run under your floors and sometimes through your walls. Most of the time, they take care of themselves and you never need to think about them.
Dirty waste water, after all, leaves your house following the law of gravity. Waste water goes downward to the sewer or septic tank, nice and easy. Behind this simple rule is the multitude of vents and traps to keep the process of waste removal possible. Vents allow air to fill drainpipes, precious air that allow waste water outflow. Traps are those curved S-shaped sections of the pipes under the sink drain. Traps perform a crucial role in forcing most of the water through the drainpipe, but leaving some to seal the area and prevent sewer gas from backing up.
As with anything, when you are not sure how to fix a plumbing issue and when you don't have the proper equipment, you should contact a professional. They can usually find out what the problem is and resolve it for you in a short period of time. They will also be able to tell you if you have any other problems and water line repair they can suggest resolutions.
Turn the water off at the main shutoff valve at the street. You should be able to take a pair of pliers(or your bare hands) and turn the valve at the water meter to shut off the water to your home. Once you have shut off the water you can cut the pipe around the leak and make the repair.
The plumber you hire does not normally do heating but will do hot water heating or in floor heating in the house. Some places you can use the water heater for both domestic hot water and for in floor heating if the heating is a secondary heat. Check with your local plumbing codes on this to be clear.